Five Essential Qualities Customers Are Searching For In Every How Much…

Ghost 2 Immobiliser Problems

The Ghost 2 immobiliser, designed to protect cars from hacking or key cloning, is a discrete device that can be installed without damaging your vehicle. It stops your vehicle from starting unless you press a specific sequence of buttons inside your vehicle, similar to the password of mobile phones.

Stop/Start

Ghost Immobilisers protect vehicles from being stolen by stopping the engine from running unless it receives the correct PIN code. This is done with no modifications to the vehicle and is totally undetectable to thieves. The unit communicates with the ECU on the CAN data bus to disable the vehicle. This is the same system the one used by car makers for a long time. However, thieves cannot overcome it using a brand new key, or key relay technology, like they could using factory-installed systems.

Ghost is compatible with any vehicle with an engine, which includes cars, vans, motorhomes and caravans, as well as bikes. The same system is compatible with electric cars. It is a great alternative to wheel clamps and steering wheel locks.

When the Ghost is activated, it will block all buttons in your car, preventing the ignition from being started without a PIN number. You can enter the code by hand or using the Android or Apple app. If the incorrect code is entered the app will show an indicator light. The Ghost will not let the vehicle be started again. This is a great method to deter thieves. If the vehicle can't be started and they are unable to get it started, they will leave.

The Ghost is a weatherproof small device that can be tucked away in the most difficult to access parts of your vehicle. Installation takes between 20 and 30 minutes for each vehicle. It is also very easy to remove if you decide to move your vehicle around or hand it in for valet parking or service. It is an TASSA (Tracking and Aftermarket Security Systems Association) an insurance-approved system, which is recognized by some insurers. It also comes with a secure emergency Pin Code override and features a Service/Valet Mode that can be activated using an app button or by using your key fob.

Disarm

Ghost immobilisers like mechanical anti-theft devices that can be removed, are concealed inside the vehicle. They are virtually impossible to hack or bypass and even if found, a thief will not be able to start the engine. A ghost immobiliser is able to prevent key cloning, as well as devices spoofing signals and signal jamming. These are the methods thieves employ to gain entry into vehicles equipped that have standard immobilisers.

An immobiliser works by sending a code to the ECU (electronic control unit). If the wrong code is received and the vehicle does not start as the engine won't fire up. It is possible to disable a ghost immobiliser by using an application program, but it would be very difficult and time consuming to do so. The software can only be installed and used by a authorized installer.

The Ghost immobiliser, a small system, is hidden within the vehicle's wiring loom. It is invisible to the naked eyes once installed. It won't show up on diagnostic systems, there are no LED indicators and it will not connect to the engine through the OBD port. It communicates silently through the CAN data circuit.

The system won't allow the vehicle to start until it is provided with an input PIN code that is entered by the user. This code is entered using buttons on the steering wheel or door panels, or central console. This is a safer way to protect the car, since it doesn't require a remote control or key fob.

In addition to this Ghost offers the option of a service mode that can be activated by using the application on your mobile phone. This will allow you to give your keys to someone for servicing or valet parking without entering the disarm sequence.

If your Ghost is in service mode or not, you should not attempt to remove the system by yourself because it could affect your engine and cause damage. It is recommended to contact an TASSA-certified installer who can safely and properly remove the system. Our latest GHOST immobilisers come with a unique fingerprint QR sticker, which is hidden in various areas of your vehicle. They are linked to our security register. In the event that the device is removed and then sold on the black market it will be able to trace the original owner.

Anti-Hijack

The anti-hijack feature is a key feature of the ghost vehicle immobiliser Immobiliser 2. This is a sophisticated key that shields your vehicle from theft. When the ignition switch is turned to on and the vehicle remains stationary for a period of 30 seconds, the Ghost system will stop the engine and turn on the hazard lights on. This gives the driver and passengers time to press the hidden security button before the system can be activated.

Contrary to many other systems that simply stop the engine once the ignition is switched to on The Ghost system has a unique controller and timer that will close the valve for cutting off fuel 14 when it is activated after an agreed-upon time even when the ignition is in operation! This delay time period must be sufficiently long to allow the hijacked owner of the vehicle to drive away from the location of the incident and to maintain a sufficient distance from the vehicle that is stalled before the system can be activated.

The Ghost has an additional layer of security that blocks common hacking techniques used to gain access to modern cars like relay attacks and key range extension. This is because the Ghost system communicates silently and doesn't emit any signals that can be detected by a criminal using codes or RF scanning technology.

The Ghost system comes with an option for service or valet mode that allows your car to be re-started and driven, without the need for PIN code. This is ideal if you park your car and only need to leave it briefly for a few minutes, like to open the garage door or place groceries in the boot. The system will end service mode according to speed and duration or through the simple PIN code entry procedure that gives you total peace of mind that only YOU are able to use your vehicle!

Keyless Entry

With the increasing trend of car thefts that are not involving contact Many people are considering additional security options. This is particularly applicable to those who have put in time or money to personalize their vehicle or own expensive vehicles. An immobiliser add-on can be a cost-effective way to prevent this kind of theft since it will stop your vehicle from starting unless the right pin code is entered into your key fob.

Immobilisers are designed for different vehicle circuits, including those which control starter motors and fuel pumps. They can also turn off the car alarm to attract attention and scare away potential thieves.

These devices connect directly to the engine control unit using the CAN data network and hinder thieves from gaining access to it by installing a replacement ECU or using key programmers. These immobilisers are installed discreetly and leave no marks in your vehicle. They are also not detected by sophisticated tools used by thieves.

The Ghost immobiliser is different from other systems that require drivers to carry a tag or an app. Instead, you are able to select your personal pin sequence by pressing a pattern on your steering wheel, door panel, and the centre console. The pin can be changed as frequently as you want, which means the device is as secure as a credit card. It can be even more difficult to break due to the fact that it requires up to 20 press.

Ghost also comes with the option of a valet/service mode that lets you deactivate the system when your vehicle is going to be handed over to valet parking or service which allows it to operate within set parameters, like a 30mph speed limit and you don't have to worry about your car being driven in reckless manner. The system can be activated with the original key or entry code.

This makes it the most effective and secure aftermarket CAN immobiliser available on the market. It is insurance-approved by Thatcham as an accessory for your car when fitted by one of our authorised installers. The Ghost 2 immobiliser is also supplied with six QR fingerprint labels and an ISR contact card that contains your unique QR code, as well as a secure emergency code that are kept in your purse or wallet of your vehicle.